| 刘俊,闫珍.染整工业园废水处理调试及运行研究[J].安徽建筑大学学报,2015,23(1):62-65 |
| 染整工业园废水处理调试及运行研究 |
| Research on Commissioning and Operation in Treatment of Dyeing and Finishing Wastement in Industrial Park |
| |
| DOI：10.11921/j.issn.2095-8382.20150114 |
| 中文关键词: 染整废水 接触氧化法 工程调试 |
| 英文关键词: dyeing and finishing wastewater contact oxidation method project commissioning |
| 基金项目: |
|
| 摘要点击次数: 6874 |
| 全文下载次数: 0 |
| 中文摘要: |
| 针对印染行业染整废水特点，采用了混凝沉淀、水解酸化和接触氧化工艺进行处理，在预处理阶段，采用絮凝剂FeSO4，当其投加浓度为500mg/L时，其对CODcr和色度的去除率分别达到31%和43%，同时增加了污水的B/C比。最终调试运行结果表明，在进水CODcr、BOD5、SS的质量浓度为1031、317、325mg/L，色度为313的条件下，去除率都能达到84%以上，出水指标均达到纺织染整工业水污染物排放标准。 |
| 英文摘要: |
| According to the characteristics of dyeing and finishing wastewater of printing and dyeing industry，the processes of coagulation precipitation, hydrolytic acidification and contact oxidation process were used. In the pre-processing stage, FeSO4 as flocculating agent, and dosing concentration at 500mg/L, its removal rate of CODcr and chroma can reach 31% and 43% respectively, meanwhile, the B / C ratio of sewage was also increasing. The final results show that the removal rate reach 84% under the influent concentration of CODcr at 1031 mg/L, BOD5 at 317 mg/L, SS at 325 mg/L, and chroma at 313. The effluent indexes meet the discharge standards of water pollutants for dyeing and finishing of textile industry |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
