| 刘俊.染整工业园废水处理调试及运行研究[J].安徽建筑大学学报,2015,23(): |
| 染整工业园废水处理调试及运行研究 |
| Research on Commissioning and Operation in Treatment of Dyeing and finishing Wastement in Industrial Park |
| 投稿时间：2014-10-14 修订日期：2014-11-20 |
| DOI： |
| 中文关键词: 染整废水 接触氧化法 工程调试 |
| 英文关键词: Dyeing and finishing Wastewater Contact oxidation method Project commissioning |
| 基金项目: |
|
| 摘要点击次数: 2720 |
| 全文下载次数: 0 |
| 中文摘要: |
| 针对印染行业染整废水特点，采用了混凝沉淀 水解酸化 接触氧化工艺进行处理。在预处理阶段，采用絮凝剂FeSO4，当其投加浓度为500mg/L时，其对CODcr和色度的去除率分别达到31%和43%，同时增加了污水的B/C比。最终调试运行结果表明：在进水CODcr、BOD5、SS的质量浓度为1031、317、325mg/L，色度为313的条件下，去除率都能达到84%以上，出水指标均达到《纺织染整工业水污染物排放标准》GB4287-2012中的排放标准。 |
| 英文摘要: |
| According to the characteristics of dyeing and finishing wastewater of printing and dyeing industry，the processes of coagulation precipitation hydrolytic acidification contact oxidation were used. In the pre-processing stage, FeSO4 were used. When its dosing concentration was 500mg/L, its removal rate of CODcr and chroma can reach , respectively,31% and 43%while increasing the B / C ratio of sewage. The final results show that: when the influent concentration of CODcr, BOD5, SS were 1031, 317, 325 mg/L、chroma was 313, the removal rate can reach 84%.The effluent indexes meet to discharge standards of 《Discharge standards of water pollutants for dyeing and finishing of textile industry》（GB4287-2012）. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
